Radyne DM240XR Spécifications télécharger pdf (Page 165)

DM240XR High-Speed Digital Modulator Front Panel Upgrade Procedure

MN-DM240XR– Revision 13 A–5

A.4.1 Running in Demonstration Mode

Because of the possible interruption in traffic when the demonstration mode expires, several

indicators are used to inform an operator that the modulator is indeed, operating in demonstration

mode. The most obvious of these is that the remote LED is flashing.

A second indication can be found on the Features Menu as follows:

1. From the modulator's Main Menu, scroll right to the SYSTEM Menu.

2. Scroll down.

3. Scroll right to the HW/FW CONFIG Menu.

4. Scroll down.

5. Scroll right to the FEATURES Menu. The second line will display DEMO.

A third indication can be found in the upgrade list as follows:

1. From the FEATURES Menu.

2. Scroll down.

3. Scroll right to the UPGRADE LIST Menu.

4. Scroll down.

5. Scroll right through the available list of options.

The top line identifies the options and the second line identifies the options status.

DEMO MODE indicates that the option is has been temporarily activated and is now available for

evaluation as part of the modulator's feature set.

At the end of the demonstration period, the modem will revert back to its permanent configuration.

When it does, an interrupt in traffic will occur, regardless of whether or not a demo enabled

features was being run at the time. In addition, operator intervention may be required to restore

the data paths. In order to avoid this interruption in service, the user can cancel the

demonstration at any time by following the instructions outlined in the section on Canceling

Demonstration Mode.

1 2 ... 160 161 162 163 164 165 166 167 168 169 170 ... 195 196

Pas de commentaire

Radyne DM240XR Spécifications Page 165