Radyne DM240XR Spécifications télécharger pdf (Page 115)

MN-DM240XR– Revision 13 9–1

Chapter 9. Remote Operations

When new features are added to Radyne Corp. equipment, the control

parameters are appended to the end of the Non-Volatile Section of the Remote

Communications Specification, and status of the features, if any, are added at

the end of the Volatile Section. If a remote M&C queries two pieces of Radyne

Corp. equipment with different revision software, they could respond with two

different sized packets. The remote M&C MUST make use of the non-volatile

count value to index to the start of the Volatile Section. If the remote M&C is

not aware of the newly added features to the product, it should disregard the

parameters at the end of the Non-Volatile Section and index to the start of the

Volatile Section.

Before creating any software based on the information contained in this

document, contact the Radyne Corp. Customer Service Department

(602-437-9620) to find out if the software revision for that piece of equipment

is current and that no new features have been added since the release of this

document.

9.1 DM240XR Opcode Command Set

The DM240XR Opcode Command Set is listed below.

9.2 Modulator Command Set

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 195 196

Pas de commentaire

Radyne DM240XR Spécifications Page 115