Radyne DMDVB20 LBST Instructions d'exploitation Page 17
- Page / 113
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
DMDVB20 LBST Satellite Modem Installation
TM138 – Rev. 1.0 2-3
Should the Power Cable/AC Connector be of the wrong type for the installation, either the cable
or the power connector end should be replaced. The power supply itself is designed for universal
AC application. See specifications for appropriate voltages and currents.
2.3 Mounting Considerations
When mounted in an equipment rack, adequate ventilation must be provided. The ambient
temperature in the rack should preferably be between 10° and 35°C, and held constant for best
equipment operation. The air available to the rack should be clean and relatively dry. The
modems may be stacked one on top of the other to a maximum of 10 consecutive units before
providing one (1) RU of space for airflow. Modems should not be placed immediately above a
high-heat or EMF Generator to ensure the output signal integrity and proper receive operation.
Do not mount the in an unprotected outdoor location where there is direct contact with rain, snow,
wind or sun. The only tools required for rack mounting are four (4) customer supplied rack-
mounting screws and the appropriate screwdriver. Rack mounting brackets are an integral part of
the front bezel of the unit and are not removable.
2.4 Initial Configuration Check
The modem is shipped from the factory with preset factory defaults. Upon initial power-up, a user
check should be performed to verify the shipped modem configuration. Refer to Section 4, User
Interfaces to locate and verify that the following configuration settings are correct:
The Interface Type (V.35, RS-422, RS-232, etc.) MUST be selected from the
Front Panel BEFORE the mating connectors are installed. Failure to do so
may cause damage to the Universal Interface Module. Power up the
modem, select the appropriate interface type, and then install the mating
connectors.
Transmit (Tx) and Receive (Rx) Interface types are dependent upon the
customer’s order.
- DMDVB20 LBST 1
- Warranty Policy 2
- Preface 4
- Trademarks 5
- Copyright 5
- Disclaimer 5
- Record of Revisions 5
- Table of Contents 6
- TM138 – Rev. 1.0 ix 8
- TM138 – Rev. 1.0 xi 10
- Introduction 12
- 1.1.1 Feature Upgrades 13
- 1.1.3 Hardware Options 13
- 1.2 Function Accessibility 13
- TM138 – Rev. 1.0 1-3 14
- Installation 15
- 2.1 Unpacking 16
- 2.2 Removal and Assembly 16
- 2.3 Mounting Considerations 17
- 2-4 TM138 – Rev. 1.0 18
- 2.5 Modulator Checkout 19
- 2.5.1 Initial Power-Up 19
- 2.6 Storage 19
- 2-6 TM138 – Rev. 1.0 20
- Theory of Operation 21
- 3-2 TM138 – Rev. 1.0 22
- 3.1.1 Front Panel 24
- 3.1.2 Baseband Processing 24
- TM138 – Rev. 1.0 3-5 25
- 3-6 TM138 – Rev. 1.0 26
- 3.3 Internal Clock 27
- TM138 – Rev. 1.0 3-9 29
- 3.5 Clocking Options 30
- 3.5.1 TX Clock Options 30
- 3.5.2.1 RX SAT Clock 32
- 3.7.3 Interleaving 33
- 3-14 TM138 – Rev. 1.0 34
- TM138 – Rev. 1.0 3-15 35
- 3-16 TM138 – Rev. 1.0 36
- User Interfaces 37
- 4.1.3 Numeric Keypad 38
- 4.2 Parameter Setup 40
- 4.3.1 Main Menus 40
- TM138 – Rev. 1.0 4-5 41
- 4-6 TM138 – Rev. 1.0 42
- TM138 – Rev. 1.0 4-7 43
- 4-8 TM138 – Rev. 1.0 44
- TM138 – Rev. 1.0 4-9 45
- 4-10 TM138 – Rev. 1.0 46
- TM138 – Rev. 1.0 4-11 47
- 4-12 TM138 – Rev. 1.0 48
- TM138 – Rev. 1.0 4-13 49
- 4-14 TM138 – Rev. 1.0 50
- TM138 – Rev. 1.0 4-15 51
- 4-16 TM138 – Rev. 1.0 52
- TM138 – Rev. 1.0 4-17 53
- 4-18 TM138 – Rev. 1.0 54
- TM138 – Rev. 1.0 4-19 55
- 4-20 TM138 – Rev. 1.0 56
- TM138 – Rev. 1.0 4-21 57
- 4-22 TM138 – Rev. 1.0 58
- TM138 – Rev. 1.0 4-23 59
- 4-24 TM138 – Rev. 1.0 60
- TM138 – Rev. 1.0 4-25 61
- 4-26 TM138 – Rev. 1.0 62
- TM138 – Rev. 1.0 4-27 63
- 4-28 TM138 – Rev. 1.0 64
- 4.4 Terminal Mode Control 65
- 4.6 Connecting the Terminal 66
- 4.7 Terminal Screens 66
- TM138 – Rev. 1.0 4-31 67
- Rear Panel Interfaces 68
- 5-2 TM138 – Rev. 1.0 69
- 5.3.5 EXT CLK (J16) 70
- 5.3.7 (J18) 70
- 5.3.8 EIA-530 (J19) 71
- 5.3.9 REMOTE (J20) 72
- 5-6 TM138 – Rev. 1.0 73
- 6.0 Periodic Maintenance 74
- 6.0.1 Clock Adjustment 74
- 6.1 Troubleshooting 74
- 6.1.1 Alarm Faults 75
- 6.1.1.1 Major Tx Alarms 75
- 6.1.1.2 Major Rx Alarms 76
- 6.1.1.3 Minor Tx Alarms 76
- 6.1.1.4 Minor Rx Alarms 77
- 6.1.1.5 Common Major Alarms 77
- TM138 – Rev. 1.0 6-5 78
- 6-6 TM138 – Rev. 1.0 79
- Technical Specifications 80
- 7.2 Demodulator 81
- 7.3 Monitor and Control 81
- TM138 – Rev. 1.0 7-3 82
- 7-4 TM138 – Rev. 1.0 83
- 7.8.2 DVB 84
- 7-6 TM138 – Rev. 1.0 85
- TM138 – Rev. 1.0 7-7 86
- 7-8 TM138 – Rev. 1.0 87
- TM138 – Rev. 1.0 7-9 88
- Product Options 89
- A-2 TM138 – Rev. 1.0 90
- B.0 Introduction 91
- B.1 Required Equipment 91
- B.2 Upgrade Procedure 91
- B-2 TM138 – Rev. 1.0 92
- B.3 Demonstration Procedure 93
- B-4 TM138 – Rev. 1.0 94
- TM138 – Rev. 1.0 95
- B-6 TM138 – Rev. 1.0 96
- Carrier Control 98
- C.5 Carrier RTS 99
- TM138 – Rev. 1.0 C-3 100
- Strap Codes 101
- D.1 Sample Applications 104
- TM138 – Rev. 1.0 D-5 105
- D-6 TM138 – Rev. 1.0 106
- TM138 – Rev. 1.0 D-7 107
- Glossary 108
- G-2 TM138 – Rev. 1.0 109
- TM138 – Rev. 1.0 G-3 110
- G-4 TM138 – Rev. 1.0 111
- TM138 – Rev. 1.0 G-5 112
- G-6 TM138 – Rev. 1.0 113
Produits connexes et manuels pour Modulateur Radyne DMDVB20 LBST
Modulateur Radyne DM240XR Spécifications
(196 pages)
(196 pages)
© 2020, manymanuals.fr. Tous droits réservés | 0.324 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels