Radyne DMDVB20 LBST Instructions d'exploitation Page 63
- Page / 113
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
DMDVB20 LBST Satellite Modem User Interfaces
TM138 – Rev. 1.0 4-27
4.3.8 Test Menu Options and Parameters
TX TEST PATTERN {NONE, 2047, 2^15-1, 2^23-1}
Allows the user to enable the tests listed above.
RX TEST PATTERN {NONE, 2047, 2^15-1, 2^23-1}
Allows the user to enable the tests listed above.
PATTERN SYNC {YES, NO}
Yes indicates that the RX Test Pattern is in sync.
TST PAT ERR CNT {NO SYNC, nnnn x 10
n
}
Displays the number of errors detected by the test
pattern checker.
TST PATT BER {NO SYNC, nnnn x 10
-n
}
Displays the measured BER for the test pattern.
RESTART TST PAT ((ENTER)) Allows the user to restart the test by pressing <ENTER>
on the keypad.
LOOPBACK WITH ETHERNET DATA INTERFACE
Usage of the modems loopback capabilities in conjunction with the Ethernet data
interface can produce undesirable network loops. In order to run any type of data test
with an Ethernet interface
y
ou must utilize two modems connected back to back. Simpl
y
using one modem and a loopback will not produce the desired results.
LOOPBACK {NONE, TERR TX, BASEBAND TX, IFEC TX}
Terrestrial Loopback is performed at the Terrestrial
Interface
NONE: No loopback performed.
TERR TX: Sends Tx Terrestrial Data to Rx data out.
BASEBAND TX: Sends Tx data to the receive input to
the BB Card.
CARRIER TYPE {NORMAL, CW, DUAL, OFFSET, POS FIR, NEG FIR}
Allows the user to set the type of carrier.
NORMAL: Causes the Modulator to output normal
modulation.
CW: Causes the Modulator to output a pure carrier.
DUAL: Causes a double sideband output.
- DMDVB20 LBST 1
- Warranty Policy 2
- Preface 4
- Trademarks 5
- Copyright 5
- Disclaimer 5
- Record of Revisions 5
- Table of Contents 6
- TM138 – Rev. 1.0 ix 8
- TM138 – Rev. 1.0 xi 10
- Introduction 12
- 1.1.1 Feature Upgrades 13
- 1.1.3 Hardware Options 13
- 1.2 Function Accessibility 13
- TM138 – Rev. 1.0 1-3 14
- Installation 15
- 2.1 Unpacking 16
- 2.2 Removal and Assembly 16
- 2.3 Mounting Considerations 17
- 2-4 TM138 – Rev. 1.0 18
- 2.5 Modulator Checkout 19
- 2.5.1 Initial Power-Up 19
- 2.6 Storage 19
- 2-6 TM138 – Rev. 1.0 20
- Theory of Operation 21
- 3-2 TM138 – Rev. 1.0 22
- 3.1.1 Front Panel 24
- 3.1.2 Baseband Processing 24
- TM138 – Rev. 1.0 3-5 25
- 3-6 TM138 – Rev. 1.0 26
- 3.3 Internal Clock 27
- TM138 – Rev. 1.0 3-9 29
- 3.5 Clocking Options 30
- 3.5.1 TX Clock Options 30
- 3.5.2.1 RX SAT Clock 32
- 3.7.3 Interleaving 33
- 3-14 TM138 – Rev. 1.0 34
- TM138 – Rev. 1.0 3-15 35
- 3-16 TM138 – Rev. 1.0 36
- User Interfaces 37
- 4.1.3 Numeric Keypad 38
- 4.2 Parameter Setup 40
- 4.3.1 Main Menus 40
- TM138 – Rev. 1.0 4-5 41
- 4-6 TM138 – Rev. 1.0 42
- TM138 – Rev. 1.0 4-7 43
- 4-8 TM138 – Rev. 1.0 44
- TM138 – Rev. 1.0 4-9 45
- 4-10 TM138 – Rev. 1.0 46
- TM138 – Rev. 1.0 4-11 47
- 4-12 TM138 – Rev. 1.0 48
- TM138 – Rev. 1.0 4-13 49
- 4-14 TM138 – Rev. 1.0 50
- TM138 – Rev. 1.0 4-15 51
- 4-16 TM138 – Rev. 1.0 52
- TM138 – Rev. 1.0 4-17 53
- 4-18 TM138 – Rev. 1.0 54
- TM138 – Rev. 1.0 4-19 55
- 4-20 TM138 – Rev. 1.0 56
- TM138 – Rev. 1.0 4-21 57
- 4-22 TM138 – Rev. 1.0 58
- TM138 – Rev. 1.0 4-23 59
- 4-24 TM138 – Rev. 1.0 60
- TM138 – Rev. 1.0 4-25 61
- 4-26 TM138 – Rev. 1.0 62
- TM138 – Rev. 1.0 4-27 63
- 4-28 TM138 – Rev. 1.0 64
- 4.4 Terminal Mode Control 65
- 4.6 Connecting the Terminal 66
- 4.7 Terminal Screens 66
- TM138 – Rev. 1.0 4-31 67
- Rear Panel Interfaces 68
- 5-2 TM138 – Rev. 1.0 69
- 5.3.5 EXT CLK (J16) 70
- 5.3.7 (J18) 70
- 5.3.8 EIA-530 (J19) 71
- 5.3.9 REMOTE (J20) 72
- 5-6 TM138 – Rev. 1.0 73
- 6.0 Periodic Maintenance 74
- 6.0.1 Clock Adjustment 74
- 6.1 Troubleshooting 74
- 6.1.1 Alarm Faults 75
- 6.1.1.1 Major Tx Alarms 75
- 6.1.1.2 Major Rx Alarms 76
- 6.1.1.3 Minor Tx Alarms 76
- 6.1.1.4 Minor Rx Alarms 77
- 6.1.1.5 Common Major Alarms 77
- TM138 – Rev. 1.0 6-5 78
- 6-6 TM138 – Rev. 1.0 79
- Technical Specifications 80
- 7.2 Demodulator 81
- 7.3 Monitor and Control 81
- TM138 – Rev. 1.0 7-3 82
- 7-4 TM138 – Rev. 1.0 83
- 7.8.2 DVB 84
- 7-6 TM138 – Rev. 1.0 85
- TM138 – Rev. 1.0 7-7 86
- 7-8 TM138 – Rev. 1.0 87
- TM138 – Rev. 1.0 7-9 88
- Product Options 89
- A-2 TM138 – Rev. 1.0 90
- B.0 Introduction 91
- B.1 Required Equipment 91
- B.2 Upgrade Procedure 91
- B-2 TM138 – Rev. 1.0 92
- B.3 Demonstration Procedure 93
- B-4 TM138 – Rev. 1.0 94
- TM138 – Rev. 1.0 95
- B-6 TM138 – Rev. 1.0 96
- Carrier Control 98
- C.5 Carrier RTS 99
- TM138 – Rev. 1.0 C-3 100
- Strap Codes 101
- D.1 Sample Applications 104
- TM138 – Rev. 1.0 D-5 105
- D-6 TM138 – Rev. 1.0 106
- TM138 – Rev. 1.0 D-7 107
- Glossary 108
- G-2 TM138 – Rev. 1.0 109
- TM138 – Rev. 1.0 G-3 110
- G-4 TM138 – Rev. 1.0 111
- TM138 – Rev. 1.0 G-5 112
- G-6 TM138 – Rev. 1.0 113
Produits connexes et manuels pour Modulateur Radyne DMDVB20 LBST
Modulateur Radyne DM240XR Spécifications
(196 pages)
(196 pages)
© 2020, manymanuals.fr. Tous droits réservés | 0.048 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels